#Sagetv 6.6 serial how to

Each of the slave devices may be a Simple Motor Controller G2 or any other TTL serial device, such as a Maestro, Jrk, qik or other microcontroller.Р”Вaisy chaining serial devices using the Pololu protocol.

#Sagetv 6.6 serial how to

The following diagram shows how to connect one master and many slave devices together into a chain. For the Simple Motor Controller G2, this can be done in the РІР‚СљInput settingsРІР‚Сњ tab of the Simple Motor Control Center G2. Secondly, assign each device in the project a different device number so that they can be individually addressed by your serial commands. If you want to daisy chain the Simple Motor Controller G2 with other devices that use the Mini SSC protocol, you can use the Mini SSC protocol. If you want to daisy chain the Simple Motor Controller G2 with other devices that use the Pololu protocol, you can use the Pololu protocol. If you want to daisy chain several G2 Simple Motor Controllers together, you can use a mixture of both protocols. You must make sure that no serial command you send will cause unintended operations on the devices it was not addressed to. This section is a guide to integrating the Simple Motor Controller G2 into a project that has multiple TTL serial devices that use a compatible protocol.Р”Р‡irst of all, you will need to decide whether to use the Pololu protocol, the Mini SSC protocol, or a mix of both (see Section 6.2).